Models > FCE4041B

FCE4041B Jenn-Air Range - Overview

Get Parts and Repair Help for FCE4041B

If you know the range repair part you need, you can browse the list of all parts on the FCE4041B, or you can search by name or part description. You can also find your part by where it is located on the FCE4041B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for FCE4041B parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Light Bulb - 40W

Sold individually.


Bake Element

This oven bake element with push-on terminals has a terminal depth of three inches. It is found on the bottom of the oven.


Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.



This screw is sold individually.


Element Infinite Switch - 8"

This is the left front element switch.


Oven Rack

Used in the lower oven. Sold individually.


2 Piece Broiler Pan

The top of this part is now black.


Door Gasket

This oven door gasket comes with built in retaining clips.



Sold Individually.


Broiler Drawer Support - Front

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned in half

  • Customer: mike from gold bar WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 502 of 501 people found this instruction helpful
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you. read more

No heat - element had burst.

  • Customer: John from Marion IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 230 of 294 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 102 of 110 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more