Models > FAV9800AWQ

FAV9800AWQ Maytag Washer - Overview

Get Parts and Repair Help for FAV9800AWQ

If you know the washer repair part you need, you can browse the list of all parts on the FAV9800AWQ, or you can search by name or part description. You can also find your part by where it is located on the FAV9800AWQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FAV9800AWQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Hose Clamp

This hose clamp is sold individually.

$111.73

Drain Pump - 60Hz 120V

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$2.70

Inlet Hose Gasket

$7.86

Leveling Leg and Pad

This part includes locknut.

$3.96

Hinge Bushing

$2.70

SCREW

Sold Individually.

$9.80

INLET HOSE

$3.96

Single Washer Inlet Strainer

Found at the end of the inlet hoses.

$3.54

SCREW

$39.45

Outer Tub Splash Guard

*May be different in appearance but will function as the original part.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

OLD PUMP STOPPED DRAINING THE MACHINE- IMPELLER IN PUMP WORE OUT

  • Customer: Deborah from Westfield MA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 42 of 47 people found this instruction helpful
FIRST- I UNPLUGGED AND COMPLETELY DRAINED MACHINE OF WATER BY PUTTING HOSE AT GROUND LEVEL NEAR DRAIN .

SECOND- REMOVED BACK PLATE TO WASHER
SAVING ALL HARDWARE.

THIRD- DISCONNECTED IN AND OUT HOSE TO PUMP. TWISTED PUMP GENTLY AS TO POP IT OUT OF SLOTS IN BOTTOM OF MACHINE.

FOURTH- DISCONNECTED WIRES TO OLD PUMP HOOKED T... read more

Belt Broke

  • Customer: Nicole from Ottsville PA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 12 of 13 people found this instruction helpful
Luckily, I found someone else with the same story, and read that you need the clutch assembly and the belt at the same time. One night when we started the washer, it made a metal seizing type squeal. There was smoke everywhere. After opening the washer, the belt burned through but the clutch had also seized which was the cause. Replaced both. Needle bear... read more

Washer would not drain

  • Customer: Scott from Sedalia MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 11 of 15 people found this instruction helpful
Starting out I found the code that the washer was showing,ND, Meaning no drain so I read up on and people where saying that the pump had a blockage in it, so I took the back of the washer to gain acess to the pump, I took the drain hose off to look in side to see if there was a problem there was nothing in the pump itself so I started to remove the pump I un... read more