Models > FAM18HR2A1 > Instructions

FAM18HR2A1 Frigidaire Air Conditioner - Instructions

All installation instructions for FAM18HR2A1 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the air conditioner repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the FAM18HR2A1
1-3 of 3
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

fried pc board

  • Customer: Bryan from Shallotte NC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 7 people found this instruction helpful
took out old pc board held by screws and put new one in .....if it were not for this co. I would be out 400 bucks for a new ac unit ... THANKS !!!!!

Bad relay

  • Customer: larry from midland TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I pulled the unit out of the cabinet, and got into the wiring panel with a Phillips screwdriver. I pulled the wires off of the old relay and put them back onto the new one. I put the cabinet back together and turned the unit on !!!! Worked like a champ... Thank so much

ON/OFF BUTTON ON A/C WOULDN'T WORK AT TIMES

  • Customer: Damian from Lutcher LA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I noticed that the A/C wouldn't come on after i pressed the ON button. Then later that night A/C would kick on by itself and it was blowing cold. I took a shot and ordered the display board that also contains ON/OFF button. First thing I did (and most important part) is remove plug from outlet. Then I removed front panel, which required removal of 4 phillips head screws. That allowed me access to PC board. PC board had just one phillips head screw. Pulled board away from unit slightly and unplugged the board from wire harness. It was very simple to do. Just reverse to install new board. Again, you MUST unplug unit before any maintenance. Now unit runs better than ever!!
All Instructions for the FAM18HR2A1
1-3 of 3