Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FAFW4011LW0

FAFW4011LW0 Frigidaire Washer - Overview

Get Parts and Repair Help for FAFW4011LW0

If you know the washer repair part you need, you can browse the list of all parts on the FAFW4011LW0, or you can search by name or part description. You can also find your part by where it is located on the FAFW4011LW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Door Strike

This is a strike for washing machine. This part activates the door switch.


Door Hinge with Bushings

This part attaches to the outside of the front door panel to help with the door open and closing properly.


Bellow Kit

Also known as a Door Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub ...


Outer Door Panel - White

This is not the complete door.



Sold individually.




Spring-Held Bellow Clamp


Dispenser Drawer




Door Glass

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Old Bellow Ripped

  • Customer: Peggy from New Castle, PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 211 of 290 people found this instruction helpful
remove top of machine by removing 3 screws along the top edge in the back of your machine and then sliding the top back and up. Then loosen the screws holding on the control panel enough to get to the 2 screws at the top of the door panel. Next remove bottom panel by removing 2 screws along bottom edge then pulling it free from snaps. Then along the outside ... read more

Striker broke while closing door due to misalignment from sloppy hinge.

  • Customer: Joseph from Hope Valley, RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 89 of 113 people found this instruction helpful
Disassembled the door panel(7screws).Replaced the outer door panel keeping the existing hinge bushings in proper alignment (requires two people because of the weight of the glass door bubble). You could remove the entire door by removing the metal hinge, however, these screws would not come out for me. Replaced the striker by removing two screws. read more

replace door striker

  • Customer: Berend from New Haven, VT
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 50 of 53 people found this instruction helpful
The striker is really easy to replace. Remove 2 #3 phillips screws, replace the striker part, and tighten the screws.

It got more complicated when too many striker tips broke off inside the latch assembly and prevented the tip of the new striker from going inside. To get at the latch assembly, I had to remove the big rubber gasket that connects ... read more