Models > FA2130

FA2130 Amana Washer - Overview

Get Parts and Repair Help for FA2130

If you know the washer repair part you need, you can browse the list of all parts on the FA2130, or you can search by name or part description. You can also find your part by where it is located on the FA2130 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FA2130 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$2.70

Inlet Hose Gasket

$3.96

Single Washer Inlet Strainer

Found at the end of the inlet hoses.

$2.70

Screw - 12-14 x 1/2 Type B

$4.46

Rubber Foot Pad

This pad is used for the levelling legs of many washing machines.

$4.60

Nut

$4.60

Screw - 8-18 x 1/2

Sold individually.

$3.83

NUT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water Inlet Valve Damaged

  • Customer: Ronald from Arcadia CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Wrench(Adjustable)
  • 5 of 5 people found this instruction helpful
The Speed Queen people were nice enough to provide a swing out door on the back of the machine to access the mixing valve. I had to pry it open because they did not supply enough slack in the hose that attaches to the mixing valve. The hose clamp securing the outlet hose to the valve was difficult to remove as the screw was positioned by someone that assem... read more

Bad tube seals and bearings

  • Customer: DAVID from SANDY HOOK CT
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Socket set, Wrench set
  • 1 of 1 people found this instruction helpful
Disassembled washer as per directions with seal kit. Removed inner tub. Cut both tub shaft bearing in half; punched out from outter tub. Installed new bearings using .5 inch threaded rod, washer and bolts. Installed new seal on inner tub shaft. Installed inner tube. Re-assembled washer. read more

Leg was mssing after move into new home.

  • Customer: Matthew from The Woodlands TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Purchased x4 new adjustable legs. Leaned the washer back and held in place with block of wood. Loosened the two older front legs with an adjustable wrench because they had a locking nut and replaced with new legs. Repeated process on back side of washer. Once all the new legs were installed leveled the machine adjusting the legs if necessary. read more