Models > F9207W0

F9207W0 Roper Range - Overview

Get Parts and Repair Help for F9207W0

If you know the range repair part you need, you can browse the list of all parts on the F9207W0, or you can search by name or part description. You can also find your part by where it is located on the F9207W0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$8.22

Surface Burner Plug-In Block Kit

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.

$23.61

Burner Switch Kit

This push-to-start Robertshaw style replacement for load rated switches has a clockwise rotation. It also has a break off shaft, and comes with plastic adapters.

$29.90

SWTCH-LITE

$51.33

Delta Frame Surface Unit - 8"

This electric range delta frame surface element with looped terminal ends measures eight inches and has five turns. It carries 2600 watts the center medallion is black in color.

DISCONTINUED

DISCONTINUED

xInsulation Retainer-Lower

DISCONTINUED

Cushion-Oven Door (3 Req)

xScrew 10-32x1

Common Symptoms of the F9207W0 [Viewing 1 of 821]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner would not heat

  • Customer: Edward from Malvern AR
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 19 of 25 people found this instruction helpful
First i shut off the power since this is an electric cook top/range. I then removed the knob and the two screws that hold the burner switch in place. I removed the wires one at a time and connected each to the new switch. I then reattached the screws to the switch. The most difficult part to me was breaking off the switch stem at the right level. I got ... read more

One burner didn't work all the time the other would go red hot

  • Customer: Phillip from Pekin IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 8 people found this instruction helpful
I unplugged the stove from the outlet, then removed the two burners I was going to be working on and the drip pans. Then I raised the top part of the stove and removed the screws holding the plug-in blocks to the stove. Then I cut the two wires going to the old plug-in block and stripped the wires back to match the new wire parts. Then I placed the sleeves o... read more

The switch had shorted

  • Customer: Stephen from COlleyville TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 7 of 10 people found this instruction helpful
I reviewed the schematic. Removed the outer casing. Pulled out the existing wires and replaced them exactly on the new switch. Snipped out off the control stem to match the others. There was a small metal piece on the old stem which holds on the knob. I removed it from the old stem and put it on the new stem and Eureka. read more