Models > F81M185BW1

F81M185BW1 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for F81M185BW1

If you know the refrigerator repair part you need, you can browse the list of all parts on the F81M185BW1, or you can search by name or part description. You can also find your part by where it is located on the F81M185BW1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for F81M185BW1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the F81M185BW1 [Viewing 4 of 4]

$19.35

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$6.68

Freezer Door Key

This metallic freezer door key is used for most upright or chest freezers.

$4.38

SCREW

$6.43

Single Gasket Retainer Clip

Sold Individually.

$6.71

Interior Drain Plug

$4.55

GROMMET

$9.06

DRIER-FILTER

$4.16

Drain Plug

$36.09

Lid Hinge Assembly

Used with Chest Freezers.

$16.39

COLD CONTROL KIT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Clicking sound then within a minute clicking again, not cooling.

  • Customer: Melvin from Semmes AL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 57 of 64 people found this instruction helpful
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby r... read more

buttom of refrigerator not cold

  • Customer: Giuseppe from brick NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 13 of 15 people found this instruction helpful
unplug it, pulled compressor start relay,which i thing it was the problem, but i replace bolt, very easy. read more

Stopped working, cooling.

  • Customer: Jennifer from Jonestown TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 13 people found this instruction helpful
I used a small screwdriver to disconnect wires from old starter. I connected the overload and starter, two wires. I put the unit back in the keeper, plugged the unit in, turned up the thermostat and it's working beautifully. read more