Models > F5108W0

F5108W0 Roper Range - Overview

Get Parts and Repair Help for F5108W0

If you know the range repair part you need, you can browse the list of all parts on the F5108W0, or you can search by name or part description. You can also find your part by where it is located on the F5108W0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for F5108W0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.96

Drip Bowl - 6"

$5.69

Drip Bowl - 8"

$9.80

Surface Burner Plug-In Block Kit

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.

$31.28

Surface Burner - 8" - 2600W

***Please NOTE: The manufacturer recommends that you replace the burner receptacle at the same time.

$2.70

Cover Screw

Sold individually.

$23.61

Burner Switch Kit

This push-to-start Robertshaw style replacement for load rated switches has a clockwise rotation. It also has a break off shaft, and comes with plastic adapters.

$18.07

2 Piece Broiler Pan

$2.70

Screw

This screw is sold individually.

$11.63

Main Power Terminal Block

$2.70

Screw

Common Symptoms of the F5108W0 [Viewing 1 of 1048]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

8 inch burner wouldn't come on. Wires shorted out

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 34 of 40 people found this instruction helpful
One screw holds the block onto the stove top. Had to clean out fitting for phillips screwdriver or screw would have stripped because it was old with lots of buildup. Even cleaned out, this screw required great force with phillips screwdriver to keep from stripping. Caution! If you strip it, you'll have to drill it out! The rest was a snap. Cut the old wires ... read more

Burner would not heat

  • Customer: Edward from Malvern AR
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 23 people found this instruction helpful
First i shut off the power since this is an electric cook top/range. I then removed the knob and the two screws that hold the burner switch in place. I removed the wires one at a time and connected each to the new switch. I then reattached the screws to the switch. The most difficult part to me was breaking off the switch stem at the right level. I got ... read more

One burner didn't work all the time the other would go red hot

  • Customer: Phillip from Pekin IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 7 of 7 people found this instruction helpful
I unplugged the stove from the outlet, then removed the two burners I was going to be working on and the drip pans. Then I raised the top part of the stove and removed the screws holding the plug-in blocks to the stove. Then I cut the two wires going to the old plug-in block and stripped the wires back to match the new wire parts. Then I placed the sleeves o... read more