Models > F4858W0

F4858W0 Roper Range - Overview

Get Parts and Repair Help for F4858W0

If you know the range repair part you need, you can browse the list of all parts on the F4858W0, or you can search by name or part description. You can also find your part by where it is located on the F4858W0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for F4858W0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$18.02

Dryer Door and Washer Lid Switch Kit

This kit is simple on/off mechanism that prohibits the machine from operating when the door is open.

$66.33

Round Carborundum Oven Igniter

This round style carborundum gas oven igniter has an amperage range between 2.5 and 3.0 amps. Be very careful when handling this igniter as it is very fragile. Please note - this will not replace the flat style igniters. Also known as bake and broil igniter.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

DISCONTINUED

SENSOR

DISCONTINUED

SERVICE MOTOR-60 CYCLE (PRODUCTION MOTORS 296086, 295976 OR 295977)

GLASS-D00R

Cushion-Oven Door (3 Req)

DISCONTINUED

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The lower burner would not ignite.

  • Customer: Mark from Rego Park NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 46 of 49 people found this instruction helpful
First I removed the oven racks. Then I loosened the two screws in the back of the oven floor and figured out how to remove it. Then I loosened the two screws at the front of the diverter and, with some pushing and pulling and twisting, was able to get that to come out, too. Then I tried lighting the oven and noticed that the igniter was not glowing. When... read more

Lid closes, switch wouldn't turn on machine.

  • Customer: Kenneth from Wilmington IL
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 16 of 19 people found this instruction helpful
Used toothpick for a year to push switch acctuator far enough to engage switch. Broke my foot and found time to order part thru PartSelect. Went from cast to boot and received part 2 days after ordered. Had difficulty with foot and getting to switch. Went back into PartSelect and figured out how to dis-assemmble panels thru the diagrams. Time on my job doesn... read more

Washer would fill up, wash, then stop

  • Customer: Glen from Plano TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 11 of 12 people found this instruction helpful
I deduced the lid switch was the problem.

I removed the two screws holding the control panel on. Pulled the control panel back.
Disconnected the ground wire of the lid switch.
removed the two top clamps that hold the panel to the top of the machine.
Pulled back the casing (outside of the washer) and placed it on it's side on ... read more