Models > F44P21ATW0

F44P21ATW0 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for F44P21ATW0

If you know the refrigerator repair part you need, you can browse the list of all parts on the F44P21ATW0, or you can search by name or part description. You can also find your part by where it is located on the F44P21ATW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for F44P21ATW0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.21

Defrost Timer - 60Hz 120V

This defrost timer will cycle for thirty minutes after every eight hours of run time.

$19.35

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$12.91

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fah...

$3.37

Crisper Drawer Cover Support

$7.73

Door Shelf Retainer Bar End Cap - Left or Right Side

It can be used with either the right side or the left side refrigerator and freezer door shelves.

$23.91

Evaporator Fan Blade

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$49.46

Door Rack - Cut-to-Fit

This rack may be longer than what is needed. You will need to cut this rack to make it fit your appliance.

$5.84

Screw

This screw is sold individually.

$6.87

SOCKET-LIGHT/LAMP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge got warm and freezer coils were frosted

  • Customer: Stephen from Warrington PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 171 of 190 people found this instruction helpful
Fridge is a side by side. The freezer is pretty narrow for a guy with wide shoulders.

Pulled plug.

Had to remove bottom drawers then used nut driver to remove screws closest to back wall in drawer runners. Once the back screws were removed the runners could be swung up or down out of way so back cover could be removed.

On... read more

Refrigerator ran frequently and freezer door was sagging

  • Customer: Dale from Pevely MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 27 of 33 people found this instruction helpful
I pulled off the old door gasket which came off really easy. I was hoping the new one would go on as easy as just popping it in place but it didnt work. I had to remove the inside door panel. The gasket wouldnt lay entirely flat in the inside groove so I used a bead of RTV around the entire circumference which helped to hold it in place while reattaching the... read more

The evaporator coil in the freezer would cake up with ice, choking off the cold air flow into the lower refridgerator compartment. A repair man had previously replaced the defrost heater element, but this did not fix the problem.

  • Customer: Erle from Boise ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 21 of 22 people found this instruction helpful
First, unplug the refrigerator since you're working with live wires.

Remove the 4 Philips sheet metal screws holding the plastic housing that holds the temperature control to the top of the refrigerator compartment. Pull the housing down then out since there is a tube on the housing where the water flows out the back of the refrigerator during th... read more