Models > EXV1511W

EXV1511W LG Microwave - Overview

Get Parts and Repair Help for EXV1511W

If you know the microwave repair part you need, you can browse the list of all parts on the EXV1511W, or you can search by name or part description. You can also find your part by where it is located on the EXV1511W by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.09

Light Bulb - 125V 30W

$17.52

Tray,Glass

$10.52

Filter,Grease

$4.61

Filter,Charcoal

$3.09

Bracket,Idle

$1.96

Fuse,Time Delay

$1.96

Screw,Tapping

$4.61

Tape,Sealing

$3.09

Shaft,Turntable

$3.09

Socket,Lamp

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave operated but did not heat

  • Customer: Donald from Oak Ridge TN
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Initial failure of over range microwave Aug 3rd. Control Panel worked but no heat. Took to local LG authoriaed local repair place. They fixed it quickly and we re-installed it. Worked fine for 2 months then had similar failure again. Agaim took to same authorized repairer. They kept unit for 3 months but finally concluded theu could not fix it and suggeste... read more

Light bulb burned out

  • Customer: Craig from Burke VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I unscrewed the light cover, removed the burned out light bulb and replaced it with one I ordered on Partselect.com. It was very easy. read more

no heat

  • Customer: Nelia from Streamwood IL
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
unplug the unit then pull down , lot of screws are on top. open the cover . you could see the parts that need to replace on the right hand side (heavy side). disconnect wires then test the parts that need to replace by a tester to make sure that it's really broke .then unscrew part and replace . read more