Models
>
EW30MO55HSA
EW30MO55HSA Electrolux Microwave - Overview
Sections of the EW30MO55HSA
[Viewing 4 of 4]Manuals & Care Guides for EW30MO55HSA
Click to downloadInstall
Installation Instructions
(0.45MB)
Install
Installation Instructions
(1.27MB)
Manual
Owner's Manuals
(2.19MB)
Manual
Owner's Manuals
(7.69MB)
Wiring
Wiring Diagram
(1MB)
Keep searches simple, eg. "belt" or "pump".
SWITCH
PartSelect #: PS8769124
Manufacturer #: 5304493153
The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or c...
$45.04
In Stock
Questions And Answers for EW30MO55HSA
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
- < Prev
- 1
- Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Katherine
July 27, 2023
My microwave is not working. No any display. Do you have Electrolux Microwave EW30MO55HSA fuse replacement parts?
For model number EW30MO55HSA
Hi Katherine, thank you for reaching out. Based on our research, the fuse is not available separately, but comes in an assembly, part number PS1765534, with the motor switch. We hope this is what you were looking for!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Randy
November 30, 2023
How do I replace the light
For model number EW30MO55HSA
Hello Randy, thank you for your inquiry. You need to unplug the unit and remove the outer cover from the unit. Once removed, you will see the bulb holder on the vent chamber. Twist and remove the bulb holder and replace the bulb. We hope that helps!
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Common Symptoms of the EW30MO55HSA
[Viewing 2 of 2]Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Timer would run but the microwave won't start
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up.
Parts Used:
-
Tim from Chicago, IL
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
87 of 137 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
microwave wouldn't turn on but timer worked.
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a
... Read more
12 volt battery and it was bad. Ordered a new one from Part select and got it fast . Works great .
Read less
Parts Used:
-
Steve from Moorhead, MN
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
35 of 56 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Microwave would count down but not run
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the
... Read more
bad switch with the new one and replace all the wires. Reassemble the unit and you are good to go.
Read less
Parts Used:
-
Betty from Kimball, TN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
29 of 48 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!