Quick Question!

Have you ever purchased from PartSelect.com before?

Models > EV150FXKQ01

EV150FXKQ01 Whirlpool Freezer - Overview

Get Parts and Repair Help for EV150FXKQ01

If you know the freezer repair part you need, you can browse the list of all parts on the EV150FXKQ01, or you can search by name or part description. You can also find your part by where it is located on the EV150FXKQ01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for EV150FXKQ01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EV150FXKQ01

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.07

Spray Paint - 12 oz. - White

$11.53

CLIP

$14.42

Hinge Bushing

$73.44

THERMOSTAT

$61.42

INSULATION

$45.27

OVERLOAD

$5.74

PLUG-DRAIN

$5.73

VENT-PLUG

$398.66

Compressor Kit

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained profession...

$28.93

Putty

Permagum sealer for refrigerant line insulation.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake, MN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 175 of 195 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

gasket had harden. frost was building up quickly

  • Customer: LESLIE from TAPPAHANNOCK, VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 21 of 24 people found this instruction helpful
the gasket peels back to reveal the approx 20 screwsholding gasket and door shelves. removed these. removed old gasket from door panel. new gasket needs to be stretched to get on door panel. align screw holes in door panel with screw holes in gasket. attached back to freezer door. this gasket did not seal securely when closing door. this gasket was ins... read more

compressor didnt turn on

  • Customer: gerardo from el monte, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 10 of 19 people found this instruction helpful
changed the starter connected to the compressor read more