Quick Question!

Have you ever purchased from PartSelect.com before?

Models > EV120FXGW03

EV120FXGW03 Whirlpool Freezer - Overview

Get Parts and Repair Help for EV120FXGW03

If you know the freezer repair part you need, you can browse the list of all parts on the EV120FXGW03, or you can search by name or part description. You can also find your part by where it is located on the EV120FXGW03 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for EV120FXGW03 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EV120FXGW03

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.53

CLIP

$5.13

Gate Support - Right Hand

$14.42

Hinge Bushing

$16.68

Gate Support - Left Hand

$61.42

INSULATION

$45.27

OVERLOAD

$16.13

Spray - Almond

$5.74

PLUG-DRAIN

$5.73

VENT-PLUG

$398.66

Compressor Kit

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake, MN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 175 of 195 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

The handle on my freezer had broken.

  • Customer: Jo Anne from Schuyler, NE
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 12 of 14 people found this instruction helpful
Took out the 2 screws that held the old handle in place. I then lined up the holes on the new handle and put the same screws back in being careful to put the shorter one in the bottom hole. When I had tightened the screws I put on the face plate to cover the screw heads and now my frezzer looks like new again!!!!! read more

compressor didnt turn on

  • Customer: gerardo from el monte, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 10 of 19 people found this instruction helpful
changed the starter connected to the compressor read more