Models > EV120FXEN01

EV120FXEN01 Whirlpool Freezer - Overview

Get Parts and Repair Help for EV120FXEN01

If you know the freezer repair part you need, you can browse the list of all parts on the EV120FXEN01, or you can search by name or part description. You can also find your part by where it is located on the EV120FXEN01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EV120FXEN01 [Viewing 4 of 4]

$2.70

Screw

This screw is sold individually.

$2.70

SCREW

Sold individually.

$3.96

Freezer Door Key

$36.38

Compressor Relay and Overload

May differ in appearance, but functions same as original. The overload protects a motor from overheating and the relay boosts the compressor.

$28.50

Run Capacitor

$3.96

Gate Support - Right Hand

$3.83

Screw

Sold individually.

$3.83

USE WPL 3400894

$3.66

TUCHUP

$4.60

BARRIER

Common Symptoms of the EV120FXEN01 [Viewing 1 of 44]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge Air On, Not Cooling

  • Customer: Robert from Austin TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 32 of 102 people found this instruction helpful
Previous issue with this refrigerator and I figure after the Hot summer we've had in TX that it overworked itself this summer in the garage! Caught this one before all was lost as it started it's not cooling cycle on a Sunday. Ordered the identical Relay&Overload from Parts Select, 2 days later I'm back to chilling the beer again! Super service with diagr... read more

broken left arm to hold rack in

  • Customer: Roy L from Layton UT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Just put the two screw back in that i had removed. read more

Refrigerator would not get cold

  • Customer: Richard from Radcliff KY
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Took a little while to figure out that I needed a flat tip screwdriver to lift up on the top of the plastic housing in order to tip it forward and remove it. After that I used pliers to remove the wires from the old parts and place them on the new. Removing and replacing the parts was performed by hand. read more