Models > ERT2018DBRCC

ERT2018DBRCC General Electric Refrigerator - Overview

Get Parts and Repair Help for ERT2018DBRCC

If you know the refrigerator repair part you need, you can browse the list of all parts on the ERT2018DBRCC, or you can search by name or part description. You can also find your part by where it is located on the ERT2018DBRCC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ERT2018DBRCC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.87

Evaporator/Condensor Fan Grommet

$11.93

Package of 12 Screws

$27.55

Vegetable Drawer Slide Rail - Right Side

$27.55

Vegetable Drawer Slide Rail - Left Side

$8.98

Shelf Support End Cap - Right Side

$29.89

Condenser Fan Motor

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

$1.94

SCR 8-18 CA HX 1/2 S

$16.66

Door Shelf Retainer Bar End Cap - Left or Right Side

This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf.

$2.66

SCR 10-16 AB PNT20 1/2 S

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 34 of 38 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more

fridge was warm

  • Customer: ELLIS from LEANDER TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 25 of 46 people found this instruction helpful
first remove the one screw holding the cover over the defrost timer, grasp the timer and unplug from the male plug end. insert the new timer. replace the cover and the one screw. plug in the fridge enjoy.
my old fridge was 30 years old and i had to replace the timer many times. read more

freezer coil frozen solid

  • Customer: David from Greenfield IN
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 26 people found this instruction helpful
Removed the back cover of freezer to acess the coil. Turned the timer to defrost and checked the voltage across the heater. Didn't have any. Stayed on the common side of heater and measured on both sides of thermostat and one side didn't have any voltage. Shorted the thermostat wires together and heater started working. read more