Models > EPD8-69KY919W

EPD8-69KY919W Hardwick Oven - Overview

Get Parts and Repair Help for EPD8-69KY919W

If you know the oven repair part you need, you can browse the list of all parts on the EPD8-69KY919W, or you can search by name or part description. You can also find your part by where it is located on the EPD8-69KY919W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for EPD8-69KY919W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$8.22

Surface Burner Plug-In Block Kit

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw.

$18.07

2 Piece Broiler Pan

BELT, ANTENNA

RIVET, STIRRER COV

STARTER FLUORESCENT

DISCONTINUED

FOAM, VINYL 64" LONG

DISCONTINUED

DISCONTINUED

PULLEY, ANTENNA

Common Symptoms of the EPD8-69KY919W [Viewing 1 of 594]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

One burner didn't work all the time the other would go red hot

  • Customer: Phillip from Pekin IL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 8 people found this instruction helpful
I unplugged the stove from the outlet, then removed the two burners I was going to be working on and the drip pans. Then I raised the top part of the stove and removed the screws holding the plug-in blocks to the stove. Then I cut the two wires going to the old plug-in block and stripped the wires back to match the new wire parts. Then I placed the sleeves o... read more

Electric burner on stove would not work

  • Customer: Ronald from Fresno CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 5 of 5 people found this instruction helpful
The first thing I did was to turn the power off to the stove by turning the Stove circuit breaker off at the Main breaker panel. I next removed the 4 burners by pulling them out of their plug-in blocks. I then removed the four screws that held the top of the stove to the body so I could access the bad plug-in block, the screws were located under each of th... read more

Belt Antenna was broken

  • Customer: Gordon from Phoenix AZ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 4 of 5 people found this instruction helpful
I think we had used a rubber band for some years when the belt melted ( I think the motor stalled and heated the belt) The new belt works fine. The Microwave cooks more uniformly with the belt working, read more