EMO4000JBB03 General Electric Microwave - Instructions

Simple, simply lifted the old piece out of position and dropped the new piece in. A small part of the broken old piece must have fallen away and is still in the unit, but it has not gotten in the way of the new piece doing its purpose

simply unscrewed protective lens cover, and swapped bulbs--these bulbs are great--last for years

In our case getting access to the charcoal filter is complicated because the unit is mounted under an overhang of the kitchen cabinet.

slipped them into place by hand

I followed the online instructions.

I removed light bulb cover shield,took out defective bulbs and replaced with new ones. 5minute repair

Removed the microwave with the buit in housing from the cabinet. Removed microwave from built in housing. Removed outer cabinet giving access to remove control panel and smart board where switches are located. Removed control panel to get to smartboard. Removed smart board after disconnecting a few wires to allow easy removal. Individually removed and then tested each switch using multimeter. Found seondary Door Switch (bottom of smart board) operation to be intermittent (switch trip button extremely loose and rattle inside this particular switch) Ordered replacement part which came very quickly on standard shipping order. Put new switch on smart board and remounted, reinstalled control panel and reconnected various wire connectors previously disconnected. Then plugged in oven and tested for opertation - didn't work at all! But, after bleeding off capacior charge by removing connectors and discharging capacitor to ground, then reassembling control board and smart board into oven, then trying agian, it has worked perfectly ever since. Do not understand why capacitor disconnect/discharge was required but suspect this reset the control electronics. Easy fix and hope to get another 12 years out of this appliance which is used multiple times every day. Also have two other identical micorwave ovens, one is 20 years old, but these get used relatively infrequently.

One of the easiest repairs I've ever done, I have AHS, but it was way cheaper to replace it myself, took about 3 minutes and cost less than 50 dollars, remove 5 screws to take the bottom plate off, 2 screws that hold the motor on, unplug it And slap the new one in...very simple, think the wife could have handled this one, lol!

Simply removed five screws from the bottom of the microwave, removed two more screws holding the drive motor and unplugged the motor. We often have the initial urge to call an appliance repair shop, but this part was easily found on Parts Select.Serial numbers on the part had changed but their photo assured me they had the right motor.

took of the cover, replaced bulbs then replaced bulbs. One was more difficult to get in than the other but all is ok now. No more stove stop cooking in the dark:)

Took off cover. Changed filter. Attached cover.

Reviewed the instructions on this website, was super easy, 6 screws pull off cover, 2 screws for drive motor. Done. Very satisfied.

Followed the instructions supplied can't have been easier. The part was on my door step the next day. It was faster than Jimmy Johns. I will use Partselect again and will recommend when I can. Thx for the great service.

every thing is working, but no hot

Simply remove the 5 screws that holds up the bottom panel of the microwave, disconnect the plug from the drive motor and remove the one screw that holds the drive motor in place. Simply reverse the steps and you're good to go. The only challenge was re-attaching the screw for the drive motor (A bit small) but once reconnected, everything else goes smoothly.