EMO3000HWW04 General Electric Microwave - Instructions

I removed light bulb cover shield,took out defective bulbs and replaced with new ones. 5minute repair

Removed 5 cross head screws from bottom vowel and Wang down to access turntable drive motor. Removed 1 crosshead screw and electrical connector from motor and withdrew motor from the hole. Removed broken coupler and replaced with new one. Reversed previous removal procedure and checked out OK.

Removed the microwave with the buit in housing from the cabinet. Removed microwave from built in housing. Removed outer cabinet giving access to remove control panel and smart board where switches are located. Removed control panel to get to smartboard. Removed smart board after disconnecting a few wires to allow easy removal. Individually removed and then tested each switch using multimeter. Found seondary Door Switch (bottom of smart board) operation to be intermittent (switch trip button extremely loose and rattle inside this particular switch) Ordered replacement part which came very quickly on standard shipping order. Put new switch on smart board and remounted, reinstalled control panel and reconnected various wire connectors previously disconnected. Then plugged in oven and tested for opertation - didn't work at all! But, after bleeding off capacior charge by removing connectors and discharging capacitor to ground, then reassembling control board and smart board into oven, then trying agian, it has worked perfectly ever since. Do not understand why capacitor disconnect/discharge was required but suspect this reset the control electronics. Easy fix and hope to get another 12 years out of this appliance which is used multiple times every day. Also have two other identical micorwave ovens, one is 20 years old, but these get used relatively infrequently.

One of the easiest repairs I've ever done, I have AHS, but it was way cheaper to replace it myself, took about 3 minutes and cost less than 50 dollars, remove 5 screws to take the bottom plate off, 2 screws that hold the motor on, unplug it And slap the new one in...very simple, think the wife could have handled this one, lol!

Simply removed five screws from the bottom of the microwave, removed two more screws holding the drive motor and unplugged the motor. We often have the initial urge to call an appliance repair shop, but this part was easily found on Parts Select.Serial numbers on the part had changed but their photo assured me they had the right motor.

I ordered a new plate and fit perfectly. No tools. no fuss no muss. Thanks Partselect.

Reviewed the instructions on this website, was super easy, 6 screws pull off cover, 2 screws for drive motor. Done. Very satisfied.

Followed the instructions supplied can't have been easier. The part was on my door step the next day. It was faster than Jimmy Johns. I will use Partselect again and will recommend when I can. Thx for the great service.

every thing is working, but no hot

snaped right in. thanks ida

Pried the broken turntable coupler out with a screwdriver. Just press the new coupler down on the shaft of the small turntable motor. It is as easy as that!!!!!

just put them in

I removed the front plate to the microwave that had six screws and dropped the front plate down and removed the motor and installed a new one. Replaced the plate and re-plugged the microwave back in and tested the unit and was all fixed. It was a very easy installation and only took me about 20 minutes to does this

Threw the old filter away and slide the new one in without any tools ! Filter should be cleaned every month - who knew ?

replaced the glass tray and the part fit perfectly in place.