Models > EKD289 > Instructions

EKD289 Caloric Microwave Oven Combo - Instructions

All installation instructions for EKD289 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the microwave oven combo repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the EKD289
16-22 of 22
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bake Element burned out after 24 years of lot's of use

  • Customer: Terry from Sharpsburg, GA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench set
  • 0 of 1 people found this instruction helpful
The key was finding the right socket and using my 1/4 inch socet set and rachet. Remove your nuts, pull out disconnect wires, remove old element and put new one in place. One tip is turn on stove light to be able to see well while in oven.

Slow heating oven

  • Customer: Lisa from Knoxville, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 2 people found this instruction helpful
To diagnose the problem I felt of the element a few moments after turning the oven on. It was cold. (rocket science, I know). I ordered the element replacement, which arrived less than 24 hours later. I turned off the power to the oven, unscrewed the old element and pulled. The wires are attached to the element in a way that reminds me of plugging in a USB port. Plugged, screwed back in, powered up and made some banana bread.

Light bulb failure

  • Customer: Grant from Alexandria, VA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.

Lower element burned out

  • Customer: Phil from Patterson, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Just like all the others, remove the two philip's head screws, and pull the wires out far enough to remove connectors. Install connectors on new element, push the wires back into the holes, and screw the cover plates from the new element into the back wall of the oven.

replaced oven lightbulb

  • Customer: peggy ann from forest city, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
very easy

Light burned out in upper oven

  • Customer: Shirley from Las Vegas, NV
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Screwed in light bulb and glass protector

Bulb Replacement

  • Customer: Judith from Phoenix, AZ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.
All Instructions for the EKD289
16-22 of 22