Models > EIDW5905JB0A > Instructions

EIDW5905JB0A Electrolux Dishwasher - Instructions

All Instructions for the EIDW5905JB0A
1 - 15 of 44
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dispenser door broken.
Disconnect from power
Unscrewed 4 phillips screws from top of outer door.
Unscrewed 2 screws each siide of door.
Lower outer door section drops away.
Note wiring sequence on dispenser, then disconnect wires.
Unscrew 6 screws on dispenser and lift dispenser out.

Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw.
Reconnect wires to dispenser correctly.
Slide lower outer door over tabs and secure with the 4 side screws.
Ensure lower door is up under control panel and secure with the 4 top screws.

Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
Parts Used:
Detergent Dispenser
  • C from Covina, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
56 of 67 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
large holes in the bottom of the basket where pieces of plastic kept breaking off
I replaced the basket. No tools necessary. New basket seems sturdier than original. Very satisfied with my purchase.
Parts Used:
Silverware Basket
  • Lauren from Peabody, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
18 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Center spray arm broke
I was able to pull out the top basket were the glasses are put then I lined up the back and the center plastic clip an slid on the center spray arm. It took about 2 miniutes
Parts Used:
Upper Rack Assembly - T3 PRO
  • Keith from Coventry, RI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
40 of 89 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
silverware basket skunked
tossed the old one a replaced with a new.Hardest 10 second repair ever....It took 10 seconds had to open and close the door.
Parts Used:
Silverware Basket
  • Alan from Holley, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
13 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
busted center portion of silverware basket
New one snaps into place easily.
Parts Used:
Silverware Basket
  • Craig from Marlborough, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
19 of 33 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Fence in dishwasher rack rusted
Unsnapped three clips in lower rack securing old fence in rack. Attached clips to new fence and snapped assembly back into rack.
Parts Used:
FOLD DOWN FENCE WI CLIPS
  • Michael from Katy, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
15 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken door on dispenser
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.
Parts Used:
Detergent Dispenser
  • Justin from Miami, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
14 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Portions of the rack had the coating wear off, exposing the metal, which began to rust.
Removing the old rack was accomplished by removing the grey retainer clips located at the end of the silver rack guides. This allows the entire upper rack to slide out of the guide tracks. Unless you purchased all of the additional parts associated with the rack you must remove the needed old parts such as the spray arm, plate guides, wheel assemblies, etc. to complete the replacement and reassembly. Each of these pieces are "snapped on" by clips that are removed with moderate difficulty. Mostly due to the apprehension that you are going to break them, however, with only the pressure exerted by your fingers they will snap off and will go actually go back on easier. The order you remove and replace the various parts is your choice. The exact positioning of the parts back on the new rack is critical, so if your memory is not good, take a quick photo with your cell phone for reference. The only tool I used was a small screwdriver to separate the clip when I first removed the rack, but in retrospect I could have removed it by hand. The key thing to remember is do not apply excess force when trying to remove the old parts, just direct pressure with your fingers. Good luck, it took me only about 15 minutes from start to finish. The best part is I probably saved $150.00 by doing it myself, figuring service time for a repairman, plus his mark-up on the parts.
Parts Used:
RACK ASSEMBLY UPPER
  • Ernest from POWELL, WY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
11 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Top spray bar rear gasket failed
Replaced the entire top rack with spray bar.
Parts Used:
Upper Rack Assembly - T3 PRO
  • tom from PASADENA, MD
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
12 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Needed to replace some racks that were rusted and coming apart
All we had to do was remove the old racks and pop in the new. Very easy to do!
Parts Used:
RACK ASSEMBLY LOWER SILVER FENCE Fold-Down Tine Row - Left Side
  • Deb from MARIA STEIN, OH
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Detergent Dispenser didn't work..
After turning of the power to dishwasher, I opened the door took of the two bottom screws on both sides of door. Closed the door and front panel just slide off. Then I took a picture of the dispenser to make use I could figure out how to put the wiring back together. Removed the six screws holding it in place and popped the dispenser out. Easy .. popped new dispenser in and lightly put all six screws back in ,wired it back up after checking my photo. Closed the door ,slid front panel back on opened the door put the 4 screws back in that hold the front panel .Turned power back on and Boom!! All done.. Not bad for a girl...
Parts Used:
Detergent Dispenser
  • Lori from IRMO, SC
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dispenser door latch broke
removed the screws holding the door together, then removed the screws holding the dispenser to the interior door. replaced the wires and put the door back together
Parts Used:
Detergent Dispenser
  • Stephanie from Fort Wayne, IN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
5 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom door gasket leak
No tools needed. Pull out old gasket. Clean the track. Ensure snug fit all across the track, use your thumb to push new gasket into the track firmly.
Parts Used:
Door Gasket - Black
  • Les from PASADENA, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishracks are rusting.
We ordered new upper and lower racks from PartsSelect. We returned the parts. Best part of our order was the help PartsSelect gave us to assist in the return. Everything we needed was included in the order. Our money was refunded immediately. Good company.
Parts Used:
Upper Rack Assembly - T3 PRO RACK ASSEMBLY LOWER SILVER
  • Norman from SUN CITY WEST, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom of Silverware gone,silverwear went to bottom of dishwasher
Your service was great, the basket came in two parts and all I had to do was put the two together and put it in the dishwasher. I am glad we were able to get a new one. Thanks again for such quick service. Thank you very much for such great service.
Parts Used:
Silverware Basket
  • Mary Pat from CAVE CREEK, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the EIDW5905JB0A
1 - 15 of 44