Quick Question!

Have you ever purchased from PartSelect.com before?

Models > EI30MH55GBA

EI30MH55GBA Electrolux Microwave - Overview

Get Parts and Repair Help for EI30MH55GBA

If you know the microwave repair part you need, you can browse the list of all parts on the EI30MH55GBA, or you can search by name or part description. You can also find your part by where it is located on the EI30MH55GBA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$32.16

Relay Switch

The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the doo...

$16.44

Light Bulb - 20W

This 20-watt lightbulb is most commonly found in the microwave. The lightbulb brightens the interior of the microwave while it is running so you can keep an eye on the food while it cooks. You will need to unplug the microwave while performing this repair. Microwaves continue to have an electrical charge directly after being unplugged, so please use caution. To access the light bulb, you will need to remove the outer cover surrounding the bulb on the top of the inside of the microwave. This is an OEM part that comes right from the manufacturer.

$30.00

Door Latch Spring

The microwave door latch spring creates tension, and engages the door latch when the door is closed. This spring is made completely of metal, and is approximately 1 inch long. If y...

$29.51

LATCH

$30.85

LEVER

$19.69

FILTER

$33.16

Grease Filter

Sold individually.

$6.67

SCREW

$6.28

Right Rear Holder

$6.07

Front Rack Holder

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Timer would run but the microwave won't start

  • Customer: Tim from Chicago, IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 71 of 110 people found this instruction helpful
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up. read more

microwave wouldn't turn on but timer worked.

  • Customer: Steve from Moorhead, MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 30 of 45 people found this instruction helpful
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a 12 volt battery and... read more

Microwave would count down but not run

  • Customer: Betty from Kimball, TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 26 of 40 people found this instruction helpful
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the bad switch with the ... read more