Quick Question!

Have you ever purchased from PartSelect.com before?

Models > EI30DS5CJS1 > Parts

EI30DS5CJS1 Electrolux Range - Parts

All parts for the Electrolux Range EI30DS5CJS1

Below is a list of all parts for the Electrolux Range EI30DS5CJS1. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the EI30DS5CJS1
1-14 of 197
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.44

Main Terminal Block Kit

Terminal block kits are also known as terminal boards, or terminal strips, and they are found in a wide variety of household appliances. Most often in ranges, wall ovens, and dryer...

$15.40

Surface Burner Cap - Black - Small 5K

Sold individually. This part helps the flame to spread for even heat. Also protects your burner head from spills.

$21.44

Surface Burner Cap - Black - Meduim 9.5K

Sold individually. This part helps the flame to spread for even heat. Also protects your burner head from spills.

$119.21

Inner Oven Door Glass

This inner oven door glass, also called an oven heat barrier glass, is a transparent and heat resistant sheet of glass that fits into your oven or range. While containing the heat, the sheet of glass acts like a window so you can see the contents in the oven. This is an original part sourced directly from the genuine manufacturer. Wait to replace the glass until the appliance is cool to the touch. This part is sold individually, and contains the glass panel only. Glass panel is approximately 20 inches by 13 inches.

$8.11

ORIFICE

$30.27

CAP

$8.61

ORIFICE

$41.63

Spark Module

This spark module or range spark module, is used in ranges and ovens. The spark module monitors and controls the spark to ignite the surface burner in a range. It does this by sending a certain amount of current to the igniter to produce that spark. If you are not getting any spark to the igniters then it is best you replace this part with a new spark module. To repair, first remove the access panel at the back of your range with a 1/4 inch nut driver to take the screws out. Next, disconnect the power harness that connects the range to the power cord to access the spark module. Take wires off using needle nose pliers and pull the spark module off the range. Match and hook up the wires to the new part. Refer to the manual provided by the manufacturer for further installation instructions and guidance.

$4.09

USE WCI 316240600

$6.36

SCREW

$38.73

CAP

$36.35

BURNER

$24.29

BURNER

$8.43

NUT

All Parts for the EI30DS5CJS1
1-14 of 197