EF36IWFSSS2 Dacor Refrigerator - Instructions

Used the instructions on your site.

Had to remove the ice-maker (also easier than trying to work inside the freezer letting all the cold air out). A few mounting screws and an electrical connection in the back. After it was out you will need to remove the cover (not the superficial cover that just pries off) where the gear is behind it, just far enough so you can get the mounting tabs on the ice-stripper in. In order to to move this cover out, after removing the screws (the obvious), you'll need needle nose pliers to ever so slightly squeeze the plastic clips together that hold the plastic movable bracket and the metal ice level arm/switch, so it will pop out. Once you have room to put the ice stripper in, it should just all snap back together, then proceed in reverse to put it all back together.

I had several times tried to get the old switch out but with no success. Ordered the "repair kit" and followed directions for removing old switch (there is a plastic spring clip on one side). Easy to unplug the old switch, plug the leads into the new one, snap the new one into place. Took about 5 minutes total--piece of cake. I wish I'd thought to try this years ago when the old switch began to fail.

Opened the refrigerator door, pulled down the filter cover, twisted the old one out and removed it. Placed the new one in - twisted it into place, replaced the cover and closed the door. It is working great!!

Take filter out of the box and open the refrigerator. Open the housing in the frig that holds the filter and twist the light-blue piece 1/4 turn, counter-clockwise. (Put the light-blue piece in a safe place.) Take foil away from filter. With 1/4 turn in the clockwise direction, twist the filter into its position. Let five gallons run through the system to get fresh, filtered water.

Ordered the left and right side parts. It took 4 time for them to send me a left side. They keeper sending the right side. It turned out that the wrong part was in the wrong ben. After they sent me the correct part it only took about 20 min to fix my refrigerator.

I popped the broken panel out and installed the replacement.

Placed in window and pulled out sliders.

No repair necessary. Just slid the new bin in . Couldn't be easier!

I went online entered the make and model. The drawings were very helpful. I was able to find the part I needed. I ordered it and it was delivered in about 4 days. I replaced the old part very easily. I couldn't believe how easy it was. I most likely saved about $200 doing it myself.

I removed the old pantry door by pushing out on the hinge pins and then installed the new door the same way. Part replacement took about 1 minute.

As per instructions to replace filter

I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!

Pretty much as described in the video except the drawer slides are held in place with phillips head screws not quarter inch nuts.

simply repalced