Models > EEV201XA0

EEV201XA0 Whirlpool Freezer - Overview

Get Parts and Repair Help for EEV201XA0

If you know the freezer repair part you need, you can browse the list of all parts on the EEV201XA0, or you can search by name or part description. You can also find your part by where it is located on the EEV201XA0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for EEV201XA0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EEV201XA0 [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$2.70

Cover Screw

Sold individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$3.86

Touch-Up Paint - White

$28.51

Light Socket Kit

The bulb is sold separately.

$65.09

Door Handle Kit of 2 - Black

Almond handle no longer available. NOTE: As per the manufacture the handle may have to be cut to fit.

$9.75

Spray Paint - 12 oz. - White

$3.96

Freezer Door Key

$6.39

Touch-up Paint - Black

$2.23

Hinge Washer

Common Symptoms of the EEV201XA0 [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Light Would Not Go On In The Refrigerator

  • Customer: DANIEL from MINNEAPOLIS MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 14 of 17 people found this instruction helpful
First I removed the old lightbulb from the socket and replaced it with a new one to confirm that the bulb was not the problem. I then pryed the socket out with a flat-head screwdriver. I could tell that the socket was anchored in its hole with clips so it was relatively easy to pry it out. Once the socket was out, I disconnected the lead wires and ordered... read more

The old door gasket was hard and frequently didn't seal and caused evaperator to ice up and contents of freezer to thaw out.

  • Customer: Vernon from Clayton NC
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 6 of 6 people found this instruction helpful
Using a nut driver on a cordless drill I took out the screws that held the metal strips on, which held the seal in place. I installed the new seal with a hand driven nut driver so as not to strip the screw holes in the door. It came out well and the new seal works very well. Getting the seal positioned properly was the most tedious part. read more

Scratches in Surface

  • Customer: Michelle from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 7 of 9 people found this instruction helpful
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great. read more