Models > EER3000L02BB

EER3000L02BB General Electric Range - Overview

Get Parts and Repair Help for EER3000L02BB

If you know the range repair part you need, you can browse the list of all parts on the EER3000L02BB, or you can search by name or part description. You can also find your part by where it is located on the EER3000L02BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for EER3000L02BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EER3000L02BB [Viewing 5 of 5]

$2.52

Light Bulb - 40W

Sold individually.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$1.70

Screw

This screw is sold individually.

$83.91

Large Haliant Burner with Limiter - 8"

$2.87

Front Drawer Support

$42.29

Exterior Oven Door Glass - Black

This is just the outer glass and NOT the complete door assembly.

$1.34

Lens

$64.11

Surface Burner Switch - 8" - 2100W

This switch controls the large burner on a range/stove top.

$2.14

Door Pad

This is the door pad only. The trim is sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 34 of 47 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Large burner would not get hot

  • Customer: Kevin from Leominster MA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 38 people found this instruction helpful
Repair was very simple. Removed 2 screws under the cooktop, tilt the cooktop back, unplug 4 wires from 8" burner, remove two screws holding retaining clips, install new burner in reverse order. Very simple! read more

The glass on our range had shattered and needed to be replaced.

  • Customer: Camie from Riveron WY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 21 of 23 people found this instruction helpful
We took detailed photos and explained exactly how to fix it step-by-step and posted it here: http://cccraftsnjunk.blogspot.com/2011/09/installing-new-glass-onto-ge-oven-door.html. read more