Models > EER3000D00TW

EER3000D00TW General Electric Range - Overview

Get Parts and Repair Help for EER3000D00TW

If you know the range repair part you need, you can browse the list of all parts on the EER3000D00TW, or you can search by name or part description. You can also find your part by where it is located on the EER3000D00TW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for EER3000D00TW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EER3000D00TW [Viewing 5 of 5]

$2.52

Light Bulb - 40W

Sold individually.

$47.30

Bake Element - Push On Terminals - 240V

This bake element is found on the bottom of the oven.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$47.23

Broil Element

This broil element is found on the upper part of the oven cavity.

$26.25

Oven Rack

Sold individually.

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$1.27

SCREW

$83.91

Large Haliant Burner with Limiter - 8"

$5.77

Foot - Leveller

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

oven element burned itself up

  • Customer: Dennis from Bondville VT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 99 of 104 people found this instruction helpful
Turned off circuit breaker to range.
Removed the 2 oven racks. Removed two screws in back of oven compartment. Pulled element forward and the terminal connections get exposed.
The right terminal clip disconnected by itself and the wire went back into the stove and could not be retrieved.
Removed range draw under the oven and pulled entire rang... read more

The baking assembly in the oven burst into flames one day, then broke apart.

  • Customer: Theresa from Sherman TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 64 of 66 people found this instruction helpful
After the element cooled down, I pulled the racks out of the oven, turned off the oven at the breaker box, then, using a nut driver, loosened the screws that held the baking assembly in the back of the oven, and pulled the connecting wires off. I bent the wires to make sure they would stay out, because if they get back in the insulation, they are hard to fin... read more

Inner glass window of oven cracked

  • Customer: Charles from Sharon MA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 30 of 32 people found this instruction helpful
1. Removed the oven door -- this is a little tricky -- you need to lift to small metal covers on the hinges, then pull the door up and out from the broil (half open position). Replace the door the same way. It is important to insert the hinges with the door in the "broil" position, and after verifying that the door is aligned and closes normally -- then li... read more