EER2000C00BB General Electric Range - Instructions

I wanted a third rack in my oven to speed up baking. This is already serving that purpose for me. No trouble at all and very fast delivery!Thank you!

after reading instructions on this site , i knew to take the 2 screws out of the element in the rear of the oven. As soon as i saw the wires i put the clamps on them so they wouldn't fall back into the wall of the oven, then i just pulled off the old element and pushed on the new. Put screws in with nut driver and turned power back on.

First I unplugged the range. Then I removed the hex head screws, disconnected the two flag connectors and removed the old element. Then I reversed the process with the new element. I plugged the range back in and set the control to broil. It works like a charm!

Pulled unit away from wall with help of husband and followed instructions.

Repairs went well. By the way you guys rock! From the easiness of your website to receiving the part a day ahead of schedule! We are baking again.

Very simple fix, after unplugging the range to shut off power, there were two screws to remove on the inside of the oven, and also removed the panel from the back with only four short screws.. the fix was simple and cost a lot less than what I would have paid to purchase a new range... The part arrived shortly after the order was placed...

Remove one screw replace element and return the screw.

replacement was easy. pulled away the stove from wall. unplug the stove. open oven door. remove the two hex head screws holdings stove top. raise the stove top in the front. supported stove top with a 16 inch piece of wood. place New Burner under old burner. remove old burner remove wires remove old burner and place it on top of new burner connected the wires from burner to new burner. install new burner. remove support lowered top down. plugged in stove tested. .burner. burner w.ork fine. reinstall hex head screws back top. pushback stove back into the wall. testes over again. all the stove work done.

Removed two screws holding the element in place, unhooked the spade connectors and inserted the new ones in their place; put the screws back in. Big deal.

removed back panel, removed 2 screws inside and unplugged element. Then reversed the process to finish.

Ordered part which arrived in 4 days. Removed range door (simple), removed shelves. With a power nut driver, removed support brackets holding element from top of oven. Removed screws holding element and temp probe at the rear of oven. Removed 2 wire connectors attached to element. Removed damaged element. Attached the replacement element to the 2 wire connectors and fed cables and probe wires back into the cable opening at the rear of the oven. Attached the new element to the top of the range with the existing screws. Attached the rear of the element with the temp probe with screws at the rear of the oven. Replaced range door. Plugged in power and tested for 15 minutes. Job complete. Parts price, great! Service call saved, priceless!

checked the voltage on baking element looked on line for part when it came in just replacled it. It was so simple

Removed the old element and installed the new one.

Pull stove out from the wall unplug it remove the old switches and replaced them withe new one. they work just fine.

It was so easy I just unscrewed the back that was easier for me and inserted the wires and done!