Models > ECBS68WJ2WW

ECBS68WJ2WW General Electric Range - Overview

Get Parts and Repair Help for ECBS68WJ2WW

If you know the range repair part you need, you can browse the list of all parts on the ECBS68WJ2WW, or you can search by name or part description. You can also find your part by where it is located on the ECBS68WJ2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ECBS68WJ2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ECBS68WJ2WW [Viewing 3 of 3]

$2.52

Light Bulb - 40W

Sold individually.

$39.06

Oven Rack

Sold individually.

$2.23

Drawer Support

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$48.91

Broil Element - 240V

This broil element is found on the roof of the oven.

$35.14

Oven Door Gasket with Mounting Clips

$83.91

Large Haliant Burner with Limiter - 8"

$1.34

Lens

$64.11

Surface Burner Switch - 8" - 2100W

This switch controls the large burner on a range/stove top.

$5.55

Oven Light Socket - With Push In Receptacle

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Large burner would not get hot

  • Customer: Kevin from Leominster MA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 38 people found this instruction helpful
Repair was very simple. Removed 2 screws under the cooktop, tilt the cooktop back, unplug 4 wires from 8" burner, remove two screws holding retaining clips, install new burner in reverse order. Very simple! read more

COIL BURNED OUT

  • Customer: Frank from St Augustine FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 30 of 51 people found this instruction helpful
OPEN LID,UN SCREW COIL,POP IN NEW COIL SNAP HOLDERS IN PLACE,THEN COOK A STEAK read more

terminal block melted

  • Customer: jonathan from willow springs IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 22 people found this instruction helpful
The existing terminal block on my Ge oven/Range had melted due to a loose wire causing sparking and starting the plastic casing of the terminal block on fire and melting it, Part select made the part easy to find and had it at my house in 2 days. All I had to do was remove six screws to take the back sheet metal cover off of the oven. Unscrew the terminal ... read more