Models > ECBP82SM2SS

ECBP82SM2SS General Electric Range - Overview

Get Parts and Repair Help for ECBP82SM2SS

If you know the range repair part you need, you can browse the list of all parts on the ECBP82SM2SS, or you can search by name or part description. You can also find your part by where it is located on the ECBP82SM2SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ECBP82SM2SS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ECBP82SM2SS [Viewing 5 of 5]

$2.52

Light Bulb - 40W

Sold individually.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$24.98

Infinite Knob - Stainless Steel

This plastic knob is sold individually. This knob accepts a double-flat shaft.

$1.34

Lens

$5.77

Foot - Leveller

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$5.55

Oven Light Socket - With Push In Receptacle

$2.87

Front Drawer Support

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 31 of 42 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

terminal block melted

  • Customer: jonathan from willow springs IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 21 people found this instruction helpful
The existing terminal block on my Ge oven/Range had melted due to a loose wire causing sparking and starting the plastic casing of the terminal block on fire and melting it, Part select made the part easy to find and had it at my house in 2 days. All I had to do was remove six screws to take the back sheet metal cover off of the oven. Unscrew the terminal ... read more

Plastic drawer support snapped off

  • Customer: Jeff Troiano from Sayville NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 13 of 13 people found this instruction helpful
The repair went very easy. The replacement part was designed differently than the original part. It installed on the rear of the drawer with a screw as the original snapped into the side. This was a bit confusing when researching and looking up the part online. read more