Models > ECBP82SL2SS

ECBP82SL2SS General Electric Range - Overview

Get Parts and Repair Help for ECBP82SL2SS

If you know the range repair part you need, you can browse the list of all parts on the ECBP82SL2SS, or you can search by name or part description. You can also find your part by where it is located on the ECBP82SL2SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ECBP82SL2SS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ECBP82SL2SS [Viewing 5 of 5]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$1.27

Lens

$5.77

Foot - Leveller

$16.87

Broiler Pan - Large

Includes the pan and grate.

$5.55

Oven Light Socket - With Push In Receptacle

$2.79

Front Drawer Support

$80.95

Haliant Burner with Limiter - 6" - 1500W

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 29 of 39 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

COIL BURNED OUT

  • Customer: Frank from St Augustine FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 28 of 48 people found this instruction helpful
OPEN LID,UN SCREW COIL,POP IN NEW COIL SNAP HOLDERS IN PLACE,THEN COOK A STEAK read more

Heating element burned out.

  • Customer: LANCE from ORELAND PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 18 of 28 people found this instruction helpful
Unplugged range. Opened oven door and removed two screws from top of oven opening. Lifted oven top and propped up
with a 2 x 3.Unscrewed the two screws that were holding read more