Models > ECBP82SL1SS

ECBP82SL1SS General Electric Range - Overview

Get Parts and Repair Help for ECBP82SL1SS

If you know the range repair part you need, you can browse the list of all parts on the ECBP82SL1SS, or you can search by name or part description. You can also find your part by where it is located on the ECBP82SL1SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ECBP82SL1SS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ECBP82SL1SS [Viewing 5 of 5]

$2.52

Light Bulb - 40W

Sold individually.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$1.70

Screw

This screw is sold individually.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$5.77

Foot - Leveller

$1.34

Lens

$2.87

Front Drawer Support

$5.55

Oven Light Socket - With Push In Receptacle

$4.41

Light Cover

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 36 of 49 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

COIL BURNED OUT

  • Customer: Frank from St Augustine FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 32 of 53 people found this instruction helpful
OPEN LID,UN SCREW COIL,POP IN NEW COIL SNAP HOLDERS IN PLACE,THEN COOK A STEAK read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 16 of 19 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more