Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ECBP82DM2WW

ECBP82DM2WW General Electric Range - Overview

Get Parts and Repair Help for ECBP82DM2WW

If you know the range repair part you need, you can browse the list of all parts on the ECBP82DM2WW, or you can search by name or part description. You can also find your part by where it is located on the ECBP82DM2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for ECBP82DM2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ECBP82DM2WW

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$7.05

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$118.26

Haliant Element - 12"

$7.05

Light Cover

$4.52

Door Pad

This is the door pad only. The trim is sold separately.

$1.44

Lens

$44.00

WINDOW PACK ASM

$9.78

Foot - Leveller

$9.78

Oven Light Socket - With Push In Receptacle

$71.73

Exterior Door Glass

Exterior glass panel only. This is not the entire door.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford, CT
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 56 of 77 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

terminal block melted

  • Customer: jonathan from willow springs, IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 38 of 44 people found this instruction helpful
The existing terminal block on my Ge oven/Range had melted due to a loose wire causing sparking and starting the plastic casing of the terminal block on fire and melting it, Part select made the part easy to find and had it at my house in 2 days. All I had to do was remove six screws to take the back sheet metal cover off of the oven. Unscrew the terminal ... read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 24 of 29 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more