ECBP70WK4WW General Electric Range - Instructions

This website made it so easy for me to find the part I needed! Shipped promptly with no problems or delays and the rack fit perfectly in my oven.

Our son came to visit! The element was replaced in no time!

I did not separate out the wires that went to the left and the wires that went to the right when I removed the element. When I finished the repair the two days later after getting the proper bottom element ( the folks on the phone are great, much better than just figuring it our o form plan view in pictures), I blew out the oven control chip, it was spectacular!. Subsequently I disposed of this newly made oven sized paperweight and replaced it with a new oven, which upon reflection of my arts and crafts abilities, I should have done in the first place..

Installed new guides with a nut driver without any problems.

Dear PARTSELECT

My experience with you was spectacular!!!!

The oven broiler burner went out on a Sunday afternoon while my wife was using it to cook for our family dinner. We ordered it that day and it was received, installed, and working on Tuesday afternoon...



How could it be any better?



Thanks



George Crady

Removed 2 screws that held the element to the back of the oven, took off the wire connections and did the same in reverse. . . . .

Really easy fix. Unplug oven. With a 5/16 nut driver take the 5 screws out of the center long tin cover and remove. Unplug little white temperature sensor plug located between broil heating element. Open oven door and remove one screw holding temp. sensor using same nut driver and simply pull out old sensor. Install new sensor. It's that easy. No more f2 been working like a champ!!!

Parts Select delivered my item quickly and in good condition. The replacement of the baking element was very easy. The following seven steps took less than 10 minutes to complete: 1) Pull the stove from the wall and unplug the oven (This was a great opportunity to ensure the floor area was clean and free from food particles) 2) Use Pliers to remove the back panel covering 3)unhook the bake element from the wire connections 4) Remove the bake element and replace with new one 5) reconnect new element prongs to wires 6) Replace back panel 7) Plug stove into the wall and push stove back to wall. Now I am ready just in time for the holiday baking season.

Removed oven door. Removed 2 screws from heat sensor on rear upper wall of oven. Pulled unit out to access rear of unit. Removed six screws on shield on back of unit. Dis connected heat sensor wire and pulled old sensor through from inside of oven. Feed wire of new sensor through from inside and plug in. Everything in reverse. I also had the gas(propane) company come out and check the pressure coming out of the "low pres." regulator. It was low, they changed the regulator.

Removed top back plate of oven. unpluged all of the wiring plugs on the control board. Removed two screws on the control board. Removed face plate from old control board and put it on the new control board. Atteched new board with the two screws. Connected all of the plugs to new board ( all plugs are color coded to board). Re-installed oven back plate. Pluged oven in. Works great.

I called my dad and he came right over and fixed it. He is a super dad!

Took part out of package, looked at instructions and followed them. Required a screwdriver to screw part on to the drawer.

Followed the instructions that were sent to me by E-Mail.

a) Turn off 240v ckt brkr to the oven p b) In the Rear -Remove the 6 hex screws holding the protective covering c) Remove the two push-on terminals p d) In front, open door to range and remove the two screws holding the faulty bake element p e) Remove faulty bake element and replace with new one f) Replace all screws p

Remove burnt coil and replaced with new coil