Models > EC5150WV0

EC5150WV0 Whirlpool Ice Maker - Overview

Get Parts and Repair Help for EC5150WV0

If you know the ice maker repair part you need, you can browse the list of all parts on the EC5150WV0, or you can search by name or part description. You can also find your part by where it is located on the EC5150WV0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your ice maker. We’ve also included any installation videos we have for EC5150WV0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$8.37

Light Rocker Switch

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$3.56

Water Tube Kit

This tubing is 1/4'' in diameter and comes with 2 inserts. This tubing may be longer than the original, and may have to be cut.

$41.82

Nozzle and Tube Kit

This kit is intended for use with refrigerators that have a water dispenser in the door.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$2.70

Hose Clamp

This hose clamp is sold individually.

$3.96

Compression Nut

$39.77

Single Outlet Water Valve Kit

This single outlet water valve is intended for use with some commercial ice machines, and not refrigerator icemakers. It comes with a mounting bracket, two screws, and a washer.

$9.24

SCOOP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 34 of 41 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Nozzle was broken

  • Customer: Robert from Tuckerton NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 21 of 21 people found this instruction helpful
Didn't know if part was replaced from the front or back of door. Removed back/inside first. Good excuse to clean mold found in places not normally seen. The only real problem was getting the face off the dispenser without breaking it. I now know it snaps off from the bottom. To replace one little nozzle you have to replace about 10' of tube. When I pul... read more

Quit making ice

  • Customer: Chris from Flower Mound TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 15 of 17 people found this instruction helpful
This is a stand alone ice maker that uses a standard water valve. When the valve fails (usually stuck open) the water never chills enough to freeze because water is constantly flowing into the hopper. The valve is in the very front. Remove the front panel. Turn of the water supply and disconnect the valve. Replace the valve and turn on the water. Let the mac... read more