Models > E36DF7CGPS1

E36DF7CGPS1 Electrolux Range - Overview

Get Parts and Repair Help for E36DF7CGPS1

If you know the range repair part you need, you can browse the list of all parts on the E36DF7CGPS1, or you can search by name or part description. You can also find your part by where it is located on the E36DF7CGPS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for E36DF7CGPS1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$28.02

Oven Temperature Sensor

Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porc...

$3.51

Main Terminal Block Kit

$4.50

Indicator Light Lens

$5.29

Igniter/Orifice Mounting Screw

$4.23

Steel Washer

Size: 3/4 inch od x 1/4 inch id

$52.64

Oven Door Latch Motor and Switch

$73.25

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$36.00

Oven Door Light Switch

$7.54

SPACER

$5.27

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 50 of 71 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 29 of 51 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more

Oven wouldn't operated. Error code F9

  • Customer: Richard from Centennial CO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 18 of 21 people found this instruction helpful
I called a repair place. They charged $54 to diagnose, (said it needed a new latch motor) then wanted $220 to complete the repair. I checked online prices and did it myself for about 15 minutes work and the latch motor itself ($44?).

Was necessary to uplug the range, pull it away from the wall and remove the back panel sheet metal, then 3 screws ... read more