Models > E32AR75FPS4

E32AR75FPS4 Electrolux Refrigerator - Overview

Get Parts and Repair Help for E32AR75FPS4

If you know the refrigerator repair part you need, you can browse the list of all parts on the E32AR75FPS4, or you can search by name or part description. You can also find your part by where it is located on the E32AR75FPS4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the E32AR75FPS4 [Viewing 4 of 4]

$12.27

Air Filter

$85.07

Door Gasket

This white door gasket is used to seal the freezer door when closed.

$37.43

Evaporator Fan Motor with Wire Harness - 115V

This evaporator fan motor is located in the back of the freezer, and circulates air over the coils. These coils will convert the heat into cool air, which is then circulated.

$8.00

Adjustable Leveling Foot - Black

Sold Individually.

$63.79

Water Filter Base

$4.95

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

$29.18

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$50.18

Pure Advantage Water Filter

$5.27

Hinge Mounting Hexagonal Screw

Sold individually.

$4.95

SCREW-SHOULDER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No water flow to in-door water/ice dispenser

  • Customer: Richard from St. Louis MO
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 19 of 21 people found this instruction helpful
Unscrewed the water line cover. Removed the platic case around the water filter base. Everything went well until I tried to remove the two water hoses. After I finally figured out that I had to push in the release washer while pulling the hoses out, things went well. Unfortunately it took several hours of wasted time and several searches on the internet ... read more

Ice and frost were forming in a frost free freezer

  • Customer: Louise from Ocala FL
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required:
  • 21 of 29 people found this instruction helpful
The old gasket was obviously gapping, partially from age and partially from damage during a move. To make the repair, I loosened the screws that are under the gasket and hold it in, but did not remove them. Once all were loose, I removed the old gasket, then starting at the top, ran a thin bead of food grade RTV under the portion of the door that captures ... read more

WATER WAS DRIPPING FROM BASE AND I HAD NO ICE BEING MADE OR WATER IN THE DOOR.

  • Customer: john from mckees rocks PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 8 of 10 people found this instruction helpful
REMOVED THE PLASTIC WATER TUBES COVER WITH A NUT DRIVER. DISCONNECTED WATER HOSES. DROPPED CONTROL BOX ASSEMBLY WITH NUT DRIVER. REMOVED OLD FILTER BASE WITH PHILLIPS SCREWDRIVER. ASSEMBLY OPPOSITE. read more