Models > E32AR75FPS0

E32AR75FPS0 Electrolux Refrigerator - Overview

Get Parts and Repair Help for E32AR75FPS0

If you know the refrigerator repair part you need, you can browse the list of all parts on the E32AR75FPS0, or you can search by name or part description. You can also find your part by where it is located on the E32AR75FPS0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for E32AR75FPS0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the E32AR75FPS0 [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$24.34

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$12.41

Air Filter

$8.86

Fan Blade

$8.00

Adjustable Leveling Foot - Black

Sold Individually.

$63.79

Water Filter Base

$23.91

Evaporator Fan Blade

$37.43

Evaporator Fan Motor with Wire Harness - 115V

This evaporator fan motor is located in the back of the freezer, and circulates air over the coils. These coils will convert the heat into cool air, which is then circulated.

$3.71

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

$6.43

Single Gasket Retainer Clip

Sold Individually.

$50.18

Pure Advantage Water Filter

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broke a blade off of the fan

  • Customer: Milton from Camp Hill PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Wrench(Adjustable)
  • 25 of 26 people found this instruction helpful
When cleaning the coils on your refrigerator always remember rule number 1, unplug it first. I was cleaning the coils and hit the fan blade while it was moving with a brush, thus breaking off one of the fan blades. I ordered a new fan and installed it in about 15 minutes. Very easy repair. read more

No water flow to in-door water/ice dispenser

  • Customer: Richard from St. Louis MO
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 15 of 17 people found this instruction helpful
Unscrewed the water line cover. Removed the platic case around the water filter base. Everything went well until I tried to remove the two water hoses. After I finally figured out that I had to push in the release washer while pulling the hoses out, things went well. Unfortunately it took several hours of wasted time and several searches on the internet ... read more

Brand new refrigerator, but evaporator fan blade broken, causing considerable vibration and noise.

  • Customer: John from Morgantown WV
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench(Adjustable)
  • 11 of 14 people found this instruction helpful
Really, really, really easy:
1.Unplug refrigerator (electrical safety).
2.Remove cardboard cover at bottom of refrigerator (two short self-tapping bolts) with a wrench.
3.Pull old fan blade off fan motor shaft (just held on by a compression fitting--no tools needed).
4.Push new fan blade on shaft.
5. Replace cardboard cover.
6.... read more