Models > E30WD75GTT2

E30WD75GTT2 Electrolux Warming Drawer - Overview

Get Parts and Repair Help for E30WD75GTT2

If you know the warming drawer repair part you need, you can browse the list of all parts on the E30WD75GTT2, or you can search by name or part description. You can also find your part by where it is located on the E30WD75GTT2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your warming drawer. We’ve also included any installation videos we have for E30WD75GTT2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the E30WD75GTT2 [Viewing 4 of 4]

$28.02

Oven Temperature Sensor

Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porc...

$5.71

SCREW

$5.62

SCREW

$5.96

SCREW

$18.30

SPACER

$5.91

SCREW

$16.50

CLEANER-COOKTOP

$40.34

ELEMENT

$199.82

BOARD

$172.09

BOARD ASSEMBLY

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 47 of 66 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Improper temperature when baking.

  • Customer: Lorenza from Rowlesburg WV
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Moved the stove away from the wall, unhooked the electric cord and the gas pipe. In the oven, undid the two screws holding the probe. Removed two screws and removed the electrical cover panel from the stove back, disconnected the quick connect to the probe and pulled the probe from the oven. Reversding the proceedures, put the new probe into the oven, hooke... read more

Error Code F1

  • Customer: Jon from Little Silver NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I usually try the cheapest part to replace when I come to a fork In the road but I wasn't home at the time and my other half called in the "expert". He said it was the clock timer and it would be $450 to replace it. She sent him away and I bought one online for $200 and put it in only to find out that it didn't solve the problem. Did some reading and foun... read more