Models > E30MC75JSS1

E30MC75JSS1 Electrolux Oven / Microwave Combo - Overview

Get Parts and Repair Help for E30MC75JSS1

If you know the oven / microwave combo repair part you need, you can browse the list of all parts on the E30MC75JSS1, or you can search by name or part description. You can also find your part by where it is located on the E30MC75JSS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven / microwave combo. We’ve also included any installation videos we have for E30MC75JSS1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.59

Main Terminal Block Kit

Order within the next 10 hrs and your part ships today!
$28.95

Relay Switch

Order within the next 10 hrs and your part ships today!
$65.05

Meat Probe

Order within the next 10 hrs and your part ships today!
$7.46

NUT

Order within the next 10 hrs and your part ships today!
$37.79

Oven Door Light Switch

Order within the next 10 hrs and your part ships today!
$19.39

LAMP

Order within the next 10 hrs and your part ships today!
$7.46

WASHER

Order within the next 10 hrs and your part ships today!
$26.45

LATCH HEAD,RIGHT SIDE

Order within the next 10 hrs and your part ships today!
$112.00

COVER

Order within the next 10 hrs and your part ships today!
$94.84

SHELF

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Timer would run but the microwave won't start

  • Customer: Tim from Chicago IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 46 of 63 people found this instruction helpful
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up. read more

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 37 of 64 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more

microwave wouldn't turn on but timer worked.

  • Customer: Steve from Moorhead MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 21 of 31 people found this instruction helpful
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a 12 volt battery and... read more