Models > E30EW8CESS1

E30EW8CESS1 Electrolux Oven - Overview

Get Parts and Repair Help for E30EW8CESS1

If you know the oven repair part you need, you can browse the list of all parts on the E30EW8CESS1, or you can search by name or part description. You can also find your part by where it is located on the E30EW8CESS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for E30EW8CESS1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$28.02

Oven Temperature Sensor

Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porc...

$3.51

Main Terminal Block Kit

$4.23

Steel Washer

Size: 3/4 inch od x 1/4 inch id

$111.47

Bake Element - 3400W

$36.00

Oven Door Light Switch

$5.73

SCREW

$111.92

Thermal Switch

Also known as a cut-out fuse. To reset, push red button.

$302.46

Inner Door Glass

$272.23

Liner,oven assy

$209.34

Bake Element Cover

Use to hide the bake element at the bottom of the oven.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 53 of 79 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Cord was not tightened enough by delivery crew.

  • Customer: Timothy from Spring Valley AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 32 of 54 people found this instruction helpful
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screw... read more

Element burned up.

  • Customer: Lynn from Denton TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 14 of 21 people found this instruction helpful
Removed old element and plugged in new. Very simple. read more