E23CS78GPS1 Electrolux Refrigerator - Instructions

I ordered the replacement part, and when it arrived, I used a flat-blade screwdriver to remove the two glides from the old drawer and installed them on the new drawer by snapping them into place. Then I removed the sliding humidity control from the old drawer using gentle pressure, and installed it on the new drawer. Then I slipped the drawer into its place, loaded the vegetables into it, and was done in less than 5 minutes.

LOOSENED THE TWO SMALL SCREWS THAT HOLD THE ICE MAKER UP INSIDE THE FREEZER. DISCONNECTED THE WIRING HARNESS. TOOK THE OLD ICE MAKER OUT AND JUST INSTALLED THE NEW ONE IN REVERSE ORDER. LATER THAT DAY I HAD FRESH ICE FOR THE FIRST TIME IN WEEKS!

This was the last step of serial repairs to the ice crusher portion of the ice maker. I have practically replaced the entire assembly. All the blades were installed incorrectly (at factory? Afterwards?) and had bent. That caused problems for other parts. I hadn't noticed that the housing was weakened and my prior repair I did something dumb and the door on housing wasn't closing properly, so it snapped. I bought a new housing and installed it. My #1 tip is WATCH THE VIDEO! There are some things that have to be put together just so. You need things to line up and be under slight tension from springs. Last time I had it under too much tension. The door got in the way of the blades and broke. So this time I was more careful to do it correctly. Everything is working perfectly now. This design is clever, and I feel like I can diagnose and fix it again in future. "Steve's" instructional videos are a huge help. He shows exactly what to do.

Installed new support

replaced it

emptied door removed the door as shone in video it was easy

remove the old one and replace with the new one and yes it was that easy. All of the lines and wiring connectors were color coded

Just follow the instruction that come with the valve. Easy.

had to remove broken by pushing 1pin then remove.
put new one in reset pin done.

The video was very helpfull. They were fixing the same refrigerator that I have. I punched in the set pin on the old part. Removed the old part by prying it out with a putty knife. Inserted the new part and drove in the set pin. I was glad that PartSelect had my parts. The repair shop in Fort Wayne Indiana did not even show this repair part on their computer.

I removed the top cover then the top hinge and replaced the bottom bearing. The hardest part was getting half of the broken bearing out of the door cavity. I had to break it up with needle nose pliers to get it to come out.

We followed the online instructions and tah-dah it was working...

Removed top hinge; raised and removed door from lower hinge; replaced stop; rehung door.

First I removed the Item out of the trays located on the door Then I removed the two screws that held the door in place> Lift the door of its location lay it on a flat surface. Counter top on a drop cloth. Remove old broken bearing< install new bearing. Replace door, install screws. Like new. I am a female and I was very proud of myself.

removed ice maker with nut driver. replaced motor with three screws works perfect