Quick Question!

Have you ever purchased from PartSelect.com before?

Models > E23CS78EPS3 > Parts

E23CS78EPS3 Electrolux Refrigerator - Parts

All parts for the Electrolux Refrigerator E23CS78EPS3

Below is a list of all parts for the Electrolux Refrigerator E23CS78EPS3 - Side-by-side. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the E23CS78EPS3
1-14 of 318
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.93

Crisper Cover Support - Front

This crisper cover front support is used to keep the crisper shelf in place, and may need replacing if the door will not open or close. This part can be used for the front support ...

$59.10

Water Inlet Valve

The water inlet valve is also known as the water inlet valve assembly and is compatible with your refrigerator. The function of this part is to release water from the supply line when activated, and send it through to your water dispenser in your refrigerator. To make this repair you will need an adjustable wrench, a quarter inch nut driver, and a sharp utility knife. Before you begin this repair make sure to disconnect the power supply to your refrigerator, as well as disconnect the inlet water supply from the back of the refrigerator. Note that this part may appear different than the original, but is an authorized manufacturer replacement.

$4.19

Crisper Support - Rear

Replacing the rear crisper support in your refrigerator is an easy job, but to complete this repair you will need a small putty knife, a punch or a short flat blade screwdriver, an...

$8.38

Hinge Bearing

Sold individually.

$97.61

Ice Maker with Cover - 8 Cube

This Frigidaire ice maker includes the ice mold and control device. The ice maker receives water from the water inlet valve and stores water in the ice mold until it freezes. Ice i...

$14.48

Defrost Thermostat Kit

If you find that there is excessive frost in your freezer, or the freezer will not defrost, you may need to replace the defrost thermostat. The defrost thermostat kit comes with the clip, leads, and heat shrink. To access the defrost thermostat for this repair, you will need to remove your freezer shelves, as well as the back panel of your freezer. To complete this repair, you will need a 1/4-inch nut driver, a set of wire strippers and crimpers, and a heat gun or blow dryer. Before you begin this repair, be sure to disconnect the power source from the appliance.

$102.90

Rear-Mount Ice Maker Assembly

This kit includes the ice maker, power cord, bail arm, and fill cup. If your ice maker is not making or dispensing ice, or you notice a leak, you may need to replace the rear-mount...

$28.16

Door Closing Cam

Sold individually. This cam is located at the bottom of the fridge/freezer door.

$30.38

Dispenser Crusher Housing

This dispenser crusher housing may also be known as a refrigerator ice crusher housing, and is compatible with your refrigerator. The function of the dispenser crusher housing is t...

$14.33

Ribbon Cable Harness

Used in the dispenser board area.

$38.75

Crisper Glass Insert

$7.72

DRUM

This part helps push the ice threw the front plate to be crushed.

$7.30

Screw

This screw is sold individually.

$29.38

Pan Cover Insert

Glass Only. Frame not included.

All Parts for the E23CS78EPS3
1-14 of 318