E23CS75DSSH Electrolux Refrigerator - Instructions

First I removed the Item out of the trays located on the door Then I removed the two screws that held the door in place> Lift the door of its location lay it on a flat surface. Counter top on a drop cloth. Remove old broken bearing< install new bearing. Replace door, install screws. Like new. I am a female and I was very proud of myself.

removed ice maker with nut driver. replaced motor with three screws works perfect

was very easy. just ordered a new ice maker which was delivered in a few days. The installation was so simple. Just plugged the new ice maker in and hung the unit on the 2 screws. And then tightened the screws with a 1/4 in nut driver.

removed the old parts with a philips screwdriver then repalced those parts with the new parts and knocked the keeper inwith the small hammer

took existing water valve loose, removed plastic water lines and reinstalled on new valve and installed new valve into refrigerator

This is an easy repair. Unplug appliance. Remove the old water valve by unscrewing it from the frame of the refrigerator. Disconnect the cables and all the water hoses. The hose fittings are a different type: clip off the old connectors from the hose ends and push the hoses straight into the new connectors till they fit solidly. Reconnect the cables and screw the valve back onto the frame of the refrigerator.
Unfortunately, my leak was from a hose, not the valve, so this didn't actually fix it.

Water was leaking so I replaced the entire valve and just followed the color codes and thats it. Plug and play.

I pull out the broken part by push the center pin thru and then rerome all the parts. I then positioned the new part in place and push in the center pin to lock. quick and easy.

Drove pins all the way thru supports & then pryed support off. Tapped new supports in place. Watch the vidio on installing new supports. I probably wouldn't have been able to get the supports off without the trick I learned to just knock them on thru. Took all of 5 minutes to replace 4 supports.

it was a simple fix, all i had to do was remove 3 small bolts from top of door, set door aside remove 1 screw that holds door cam in place, install new door cam.hole job took about 15 minute's.

Watched the video and read some comments and from that it was easy

Due to the nature of the support deisign and installation which was unusual I watched the video on how to extract the old broken support and install the new one, odering the new part was simple as the view privided in the parts section was specific and and easy choice to make, cost was very minimal and I received it the next day due to my being in close proximity to the shipping point, thank you and my crisper is very happy and so am I.

1-Remove upper plate with phillips screw driver (6) screws 2- remove upper hinge plate with ratchet and socket (2) bolts 3- lift door off bottom cam, lay door flat on floor. 4- Remove broken cam on lower part of door, just pull out. 5- Install new cam in bottom of door 6- raise door up, set on cam, reinstall top bolts and screws 7- p. S. Make sure you trace top hinge location with a pencil before removal, so installation has proper location.

Very easy repair, instruction were clear and easy to follow

Simple, I had a repair man come over and diagnose the problem. After confirming, I ordered the part and replaced it. Need to make sure you get the ice build up out of the fitting tnat goes from the back of the fridge connection at the top and the filler tube inside the unit, mine was iced over. Repair man wanted to charge me $250.00... with his service call and buying the part, it cost $120