Models > DWD1500AWB > Instructions

DWD1500AWB Admiral Dishwasher - Instructions

All installation instructions for DWD1500AWB parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the DWD1500AWB
451-465 of 470
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

I got my parts from you

  • Customer: Angela from Whitehall WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I haven't gotten to our rental to get the job done yet but it should go real easy because the broken one came off real easy these should go on just as easy. Thanks again for the parts

The bottom grid of the silverware basket separated.

  • Customer: Irene from Holmdel NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Just ordered a new one, which came VERY quickly, and put it in!

The dishwasher door was fitted with a plastic striker. It obviously wasn't meant to last, and eventually broke. This meant that the door would not shut properly, so I couldn't use the dishwasher.

  • Customer: Judi from Katy TX
  • Difficulty: Really easy
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I pulled out the dishwasher a little to expose the screw on the striker, (located on top of the dishwasher. The annoying thing was, it wasn't a regular screw, so unfortunately I had to go out and buy a torx screwdriver (which cost more than the new striker). It would have been so much quicker, and cost effective, if it had been a normal screw. Anyway, I completed the job and pushed the dishwasher back into place.

Broken latch

  • Customer: John from Richfield MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
This was fantasticlly easy. Less than 2 minutes to remove the screws. Made a mark on each of the two wire assemblies to ensure proper replacement. Pulled off the wires. Connected the wires to the new assembly. Placed it into the opening and re-tightened all the screws. Probably five minutes! Works better than new. THANK YOU!

leaking water

  • Customer: Edgar from Round Lake IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 0 of 0 people found this instruction helpful
I removed the leaking valve and installed the new one it was pretty easy

Leaking under right front by float switch

  • Customer: James from Three Rivers MI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Unplugged the power cord and removed front toe kick panels. Used a small mirror to see the location of the screw holding the float switch in place and removed the screw, disconnected the float from inside the dishwasher removed the float switch and replaced. It was a simple repair and so far seems to have solved the leaking problem. There was some unusual wear to my old float and the switch looked like it may have been leaking a small amount as it had lime build up on the switch lever. The part came with an easy to follow instruction sheet. PartSelect has saved me money on repair work I thought I would not be able to do myself. The website is very helpful in resolving what he problem may be and what parts are needed. Fixed four other appliances using this site over the past few years and they ship quick.

latch broke

  • Customer: mike from highlands ranch CO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
easy, took 20 minutes to unscrew panel (after unplugging electricity), remove 2 electrical connections, put in new latch, reconnect 2 electrical connections & screw back on - saved $80 in having someone come out to service.

Dishes weren't getting cleaned fully

  • Customer: William from Bel Air MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Checked to see if the disposer was stuck or sprayers filled with food. They were clean so I listened and checked to see if the sprayers were spraying while the dishwasher was running. It was not. Checked online for answers and they said that there might not be enough water in the dishwasher since it did not fill appropriately. I added water during the cycle and then the sprayers were working properly until it drained and filled again. Installed the new water inlet valve and all works properly now.

no wash action

  • Customer: Reno from Lake Montezuma AZ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 0 of 0 people found this instruction helpful
followed directions on video. easy as cake

The door latch would no longer open the door.

  • Customer: James from Fair Oaks IN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
I unscrewed the inner part of the door (not the bottom screws)from the front of the dishwasher. This allowed the latch assembly to be disconnected by the two wire leads. They were tough to get off, maybe due to age and mositure but they did break loose. The new part was than connected easily to the two wire leads. I put the handle assembly back into place and put the screws back in the door. And now it works like a champ again!

handle was broken

  • Customer: Mike from South Haven MI
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
The basic repair was easy, selecting the part on-line was the hardest part of the process. I was afraid the part would be similar, not the same. But the part fit exactly. Once I deduced that the circuit breaker was off, it worked perfectly. The video was helpful to assure I installed it correctly. Thanks for your help Part Select.

dishes weren't getting clean

  • Customer: Reno from Lake Montezuma AZ
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
followed directions (boring, I know, but it works) on the accompanying video. simple

Leaking and water level

  • Customer: Ferrellin from Gleason TN
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Lifted Float out....Located Float switch ...replaced

missing plastic nut on lower wash arm

  • Customer: James from Poughquag NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 0 of 0 people found this instruction helpful
Remove lower basket. put nut on verticle shaft, turn clockise by hand, use pliers gently to secure and replave lower basket.

Cracked Silverware Basket

  • Customer: Mary from York PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Easiest ever. Recycled the old one and put the new in its place. We are trying to place the silverware in, rather than dropping it in. It was suggested in the video from this website.
All Instructions for the DWD1500AWB
451-465 of 470