Quick Question!

Have you ever purchased from PartSelect.com before?

Models > DWC6402AAE

DWC6402AAE Maytag Dishwasher - Overview

Get Parts and Repair Help for DWC6402AAE

If you know the dishwasher repair part you need, you can browse the list of all parts on the DWC6402AAE, or you can search by name or part description. You can also find your part by where it is located on the DWC6402AAE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for DWC6402AAE parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$34.02

Door Switches and Holder Assembly

This part senses when the door is closed so the cycle can start.

$185.82

Upper Dishrack with Wheels

This rack comes complete with four attached wheels and the rack may differ in appearance, but will function same as original part.

$5.38

Actuator Lever

$25.02

Timer Knob

This black knob accepts a double-flat shaft. This is used to turn your dishwasher timer to the desired start location.

$21.48

Motor Shaft Seal

This seal has a rubber exterior and a metal interior.

$6.87

Actuator Lever Pivot Pin

$4.63

Access Panel Insulation

$9.94

CONNECTOR

Inlet Water Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the d...

$30.85

Upper Rack Shelf

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water dripping from right corner of door

  • Customer: Tim from Ringgold, GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 550 of 558 people found this instruction helpful
Took out about 7 torx screws to remove the inner door liner. Discovered evidence of leak coming from the sop dispenser latch, and noticed the grommet had turned soft and was torn. The grommet is only about 1" square. Used nut driver to remove two screws to remove latch assembly. Slipped old grommet off and put new one on, and reattached the latch. The foam s... read more

Rack roller broke

  • Customer: Kathy from Lombard, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 481 of 482 people found this instruction helpful
I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks read more

The utensil basket was old, bowed and the bottom was falling out.

  • Customer: Janet from Plano, TX
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 445 of 455 people found this instruction helpful
I ordered a new replacement basket. The new one is a little different but it fits in the same place and takes up the same amount of room in the dishwasher. It looks very nice too. read more