DW761W Jenn-Air Dishwasher - Instructions

Real easy. I checked out the instruction video. It was great no problem making the repair....Thanks

Unscrew round keeper on top of spray arm -CCW. Lift off spray arm. Remove the six Torx head screws aroun pump housing. Lift off pump housing. Unplug unit and obtain a small piece of 2 x 4 wood to block up the motor underneath. Push the white plastic lever near the left side of motor towards the back to loosen the entire unit. Place the wood block uner the motor and you will see the seal is accessable inside the dishwasher. Remove the seal and very carefully clean the area that accepts the new seal. Remove the block and pull back on the white plastic lever. Done!

Replaced the door latch.

Watched video you have on the site.... also read the first person's description - both very helpful...since I am 75 y.o.and a woman got my chair to sit and did exactly step by step and actually did it! So happy I wouldnt have to buy a new dishwasher YET - Emailed my friends and said if and when they need wheel replaced I can do for them!!! Thanks for all the help on site.

Replaced the inner door foam insulation strip and door gasket.I believe the "secret" is not to push the door gasket in all the way. Let the door find its own seat. Problem fixed.

customer service was great depart was easy to install and worked like a charm

This was as simple a repair as you will ever get, at least on a 16 year old Maytag like we have. Literally just take the old gasket out and put the new one in -- just make sure to look at the old gasket to ensure you are inserting the proper end of the new one into the channel, I almost put it in wrong, but then again I'm brain damaged where home repairs are concerned. The door is more difficult to close after I put the gasket in, so I may have to adjust the door closing mechanism just a tad.

Great instructions, great service. But I have not yet made the repair.

plastic form inside dishwasher does not press into foam insulation strip hard enough to stop water from leaking. It is still leaking

It was super simple, the web site was excellent in helping me purchase the proper parts, even when a slight error was made in my order(2 parts bags were ship that were empty)I contacted the service department an they immediately sent out the parts at no charge. I replaced the dishwasher cover in about 10 minutes. Probably saved a couple hundred dollar from a service call. Thank you.

Installing the door gasket is relatively easy, it just pushes in place without any adhesive. Just make sure it is even on both sides
You can to pull it out and reinstall to even it all way around the door if needed.
You may also find a new gasket will make to door a little harder to close. I presume it will be easier to close over time.
I also installed a new float at the same time but that repair is very difficult, takes specialized tools and lots of patience.

look the instrution on line and it worked great.

After I got the new springs, I pulled the dishwasher out and the springs were fine but the little plastic piece that attaches the spring to the door was gone. So now I had to order the that piece and wait again.

The fix was straight forward and easy to figure out. I followed the very easy instructions to learn any tips that would make the job go without any problems.

At first I was confused on how to repair this, but once I was able to unscrew the large cover to reveal the inside area, it became clear on which part to replace. The screws were a star type, in which I was able to use an old IKEA hex wrench. There is a small plastic tip that unscrews in the center of this part. Once you unscrew that, the part comes right out. This is my second time ordering a part from these guys for this washer. They are awesome!! The part came in 2 days, so happy!!