Models > DU7DA-25

DU7DA-25 Maytag Dishwasher - Overview

Get Parts and Repair Help for DU7DA-25

If you know the dishwasher repair part you need, you can browse the list of all parts on the DU7DA-25, or you can search by name or part description. You can also find your part by where it is located on the DU7DA-25 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DU7DA-25

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.75

Screw

This screw is sold individually.

$2.71

Screw

This screw is sold individually.

$33.12

Cable and Eyelet

This part helps hold the door in place.

$2.68

Screw - 6-32 x 5/16

Sold individually.

$2.71

Ground Screw

$9.71

ENDCAP

$4.45

SCREW

Sold Individually.

$4.35

CLAMP

$25.09

Lower Front Wheel

WHEEL

Common Symptoms of the DU7DA-25

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Spring that holds door closed

  • Customer: Bessie from Fruitland Park, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 8 of 16 people found this instruction helpful
First, removed screws on bottom panel. On this model, everything was easy to see. Did not have to move the appliance at all. The left side wire was broken. Just removed the broken part, connected the new wire, and then the springs to it. No problem at all. Took about 15 mins. read more

Wouldn"T Drain The Water Completey

  • Customer: clarence from ST LOUIS, MO
  • Difficulty: Really Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 3 of 5 people found this instruction helpful
Removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. . . ) read more

Door mechanism broken

  • Customer: Chung from Petaluma, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 3 of 7 people found this instruction helpful
First removed the two screws and then the bottom part of the door. Replaced the broken cable & eyelet assy with the purchased part. Connect the eyelet with the two springs which tied with door mechanism with other cable/eyelet assy. Done read more