Models > DU110CA-01

DU110CA-01 Magic Chef Dishwasher - Overview

Get Parts and Repair Help for DU110CA-01

If you know the dishwasher repair part you need, you can browse the list of all parts on the DU110CA-01, or you can search by name or part description. You can also find your part by where it is located on the DU110CA-01 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DU110CA-01 [Viewing 4 of 4]

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$4.36

CLAMP

$2.70

Screw - 6-32 x 5/16

$2.70

Ground Screw

$47.27

SPRAY ARM

WHEEL

$23.37

Leveling Leg

Sold Individually.

Tub Baffle - left side

This tub baffle is two inches long. It is all black in color and is made entirely of plastic. This baffle is intended for use with some dishwashers.

BAFFLE, TUB (RT)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

WOULDN"T DRAIN THE WATER COMPLETEY

  • Customer: clarence from ST LOUIS MO
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 2 of 3 people found this instruction helpful
removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...) read more

Two upper rack rollers were broken

  • Customer: Duane from Seattle WA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent. read more

Upper rack roller cracked then broke

  • Customer: Jeffrey from Wilson NC
  • Difficulty: A Bit Difficult
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
First removed the end cover and clip on the end of the rack slide. Used a flat head screwdriver to push in the clip and carefully pried it out. Then using the same screwdriver, pried up on the rack roller clip attached to the dish rack. Once clip was free of the rack, slid the rack roller off through the front of the slider. Slid the new rack roller into... read more