Models > DU1000CGT2

DU1000CGT2 Whirlpool Dishwasher - Overview

Get Parts and Repair Help for DU1000CGT2

If you know the dishwasher repair part you need, you can browse the list of all parts on the DU1000CGT2, or you can search by name or part description. You can also find your part by where it is located on the DU1000CGT2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for DU1000CGT2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Upper Spray Arm Mount

**Please note: This is a redesigned part. The top mounting clip and screw are no longer needed.


Wash Arm Bearing Ring

This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.


Spray Arm Seal

This white under spray arm bearing ring is designed with the split. This is not a defective or damaged item.


Lower Sprayarm Nut

This part is used with the lower spray arm.


Drain and Wash Impeller Kit

This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking...


Thermal Fuse and Harness

*Please Note - When changing the fuse always use a new wiring harness.


Door Gasket - Gray

It provides a waterproof seal between the tub and the door.


Water Inlet Valve

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.


Rubber Washer

Sold individually. Used with the heating element.


Lid Spring

This metallic spring is for your dishwasher's soap cup cover.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishes not clean and lower wash arm wobbled.

  • Customer: James from Jacksonville FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 511 of 516 people found this instruction helpful
Completely removed lower wash arm and replaced bearing ring and seal. read more

Not Cleaning lightly soiled items.

  • Customer: Dennis from Cromwell CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 372 of 375 people found this instruction helpful
Removed spray arm thumb nut. Removed spray arm. replaced worn and broken earings and re-assembled in reverse order. Would have done the repair a lot sooner if I had known that PartsSelect was just a few miles up the highway. read more

Dishwasher leaking at bottom of door

  • Customer: Eileen from Salt Lake City UT
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 111 of 115 people found this instruction helpful
Installed new door seal. Dishwasher still leaked. Googled the model number and then cleaned the filter at the bottom of the dishwasher, still leaked.
Verified that manifold bearing was not work. It was OK.
Found note that a plugged vent might cause leaking door. Very counterintuitive. Pried off air vent cover. Vent was thouroughly plugged wit... read more